Important Note: This motor cannot be used as a primary pool pump in the state of California due to state regulations on energy efficiency for pool equipment. Please verify local requirements before purchasing.

• High-Performance Compatibility: The Dyneson PCG-20 is engineered as a direct-fit replacement for Pentair SuperFlo and WhisperFlo pumps, ensuring proper fitment, secure alignment, and consistent water flow performance.

• Reliable Electrical Operation: With a 2 HP rating and 3450 RPM speed, this motor operates at 230 volts, 60 Hz, providing steady single-speed output to support demanding pool and spa circulation needs.

• Heavy-Duty Frame & Mounting: Constructed with a 56Y frame and square flange, the PCG-20 is designed for robust durability, reduced vibration, and dependable operation under long-term use.

• Maintenance & System Longevity: Replacing aging or worn motors with the PCG-20 helps sustain circulation strength, improve energy efficiency, and extend the service life of your Pentair pump system.

• Backed by Warranty Protection: Supported by a two-year manufacturer warranty, this motor ensures confidence in reliable performance and durability under poolside conditions.

• Horsepower: 2.0
• Total Horsepower: 2.175
• Frequency: 60 HZ
• PH: 1
• Speed (RPM): 3450
  
• Voltage: 230

• Pentair SuperFlo Pumps
• Pentair WhisperFlo Pumps

Need help with the Dyneson 2 HP PCG-20 motor for Pentair SuperFlo and WhisperFlo pumps? This section covers installation guidance, troubleshooting questions, and in-store availability tips for a smooth replacement.

Installing the PCG-20 Motor on Pentair Pumps

This motor features a 56Y frame and square flange, making it a direct replacement. Proper installation requires 230V wiring, seal alignment, and secure mounting to prevent leaks.

How to install Dyneson PCG-20 motor on Pentair WhisperFlo pump

Correct 230V wiring steps for PCG-20 motor on SuperFlo models

Do I need a new shaft seal when installing PCG-20 replacement

Step by step guide to fitting PCG-20 into Pentair SuperFlo housing

Troubleshooting After Replacement

Leaks, overheating, or vibration are common concerns if setup isn’t done correctly. These questions help address common post-install issues.

Why does PCG-20 motor overheat after installing on Pentair pump

WhisperFlo leaking after PCG-20 replacement what to check

How to test voltage supply for PCG-20 motor on SuperFlo system

Do Pentair pumps need priming after new PCG-20 install

In-Store Availability and Fitment Help

Bring your old motor or model number to the counter for verification. Store staff can confirm compatibility and make sure you get the correct PCG-20 motor.

Buy in store PCG-20 Dyneson motor for Pentair WhisperFlo pumps

Walk in and compare PCG-20 motor with old SuperFlo version

Available locally PCG-20 replacement motor for Pentair pumps

Can store staff confirm PCG-20 fit before purchase